b. How do I perform paging using the ZP-001T in Mixer Mode?
The
ZP-001T
paging functions works very similarly to the Matrix mode, except that the routing must
be set up in the Output Assignment Page.
1.
The ZP-001T should be assigned to all outputs where the paging signal needs to appear.
2.
The Group Paging assignment should also be set to allow the page to affect different
output groups as needed (see diagram below).
3.
When any output is dialed from the phone extension all outputs which are set as part of
that group will also receive the page.
Example:
a.
Program Page Group 2= Outputs 3, 4 & 5.
b.
Dial output 3 (0, 3, #) on the extension phone.
c.
Outputs 4 & 5 also receive the page.
Ring exchange Analog Ext. (Ring Mode)
(dial 0, 3, #)
Paging Port w/contact
Telephone Extension
PBX Exchange ZP-001T
Group Paging Assignment Matrix
Paging is activated on outputs 3, 4 & 5
*Paging during power-OFF
The power switch located on the amplifier front panel is a soft-switch, and not a mechanical switch
and does
NOT
turn the power supply's primary side on or off. Therefore, there is enough internal power to
maintain an active microprocessor inside the unit, even if the power switch is set to OFF.
The following controls can be performed when the power is OFF:
• Remote power control by control input: Power can be switched on and off using the external contact.
• Event activation by control input: Turns on the unit's power and activates the assigned Event (Trigger-set
Event having the input with Priority 1 – 7) using the external contact. The unit returns to power-OFF state after
Event operation completion.
• Paging by the ZP-001T turns on the unit's power. The unit returns to power-OFF state after paging completion.
a
c
b
44