TX7302 Addressable Flashing Beacon Base
Installation & Operation Manual
2.1 Installation Preparation
This alarm warning device must be installed, commissioned and maintained by a qualified or factory
trained service personnel. The installation must be installed in compliance with all local codes having
a jurisdiction in your area or BS 5839 Part 1 and EN54.
2.2 Installation and Wiring
1.
Install the TX3980-type base in the position where the Addressable Flashing Beacon Base will
be installed. Following the arrow mark for the correct position. Do not over-tighten the screws
otherwise the base will twist. Use M4 standard screws. Terminals 1 and 6 are the bus signal
inputs for connection to the last device.
Terminals 2 and 5 are the bus signal outputs for
connection to the next device. Terminals 3&8 or 4&7 are used to connect remote indicators,
Where terminals 3&4 are positive and terminals 7&8 are negative.
TX3980-type base structure
and the terminals connection diagram as shown in Figure 1.
2.
The bottom structure of the Addressable Flashing Beacon Base as shown in Figure 2. Install
the Addressable Flashing Beacon Base on the TX3980-type base with the installation terminals
of the two devices are one-to-one. The device number or other device parameters can be
verified with a handheld programmer if desired.
3.
The top structure of the Addressable Flashing Beacon Base as shown in Figure 3. An upper
cover or a detector can be mounted on the Addressable Flashing Beacon Base, as shown in
Figure 4.
Remote Control
Light
In from
last device
Out to next
device
Remote Control
Light
Fig.1
TX3980 base structure and the terminals connection diagram
Fig.2
Bottom structure of the Base
Fig.3
Top structure of the Base
4050100452-Rev1.0-0917
TANDA UK
Specifications are subject to change without prior notice
5
