NanoCam3D Mk.1 Instruction Manual
IMPORTANT – READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
2.1 Control Elements
Figure 2: Control Elements
Status LED
State
Remark
Off
No power supply. Camera out of operation.
On
Normal operation.
Blinking
Camera in setup or adjustment mode.
2.2 Video Norm Setup
The camera’s video norm can be selected between PAL (factory default) or NTSC. It can be
changed by executing the following procedure. The video norm setup procedure can be canceled
at any time by power-cycling the camera.
Power off camera.
Press push button 1 and keep it pressed.
Power on camera and release push button 1. The camera’s status LED starts to flash.
Flashing cycle indicates current video norm setting (PAL = repeated single flash, NTSC =
repeated double flash).
Press and release push button 2 to toggle between PAL and NTSC. LED flash cycle
changes accordingly.
Press and release push button 1 to save setting and restart camera with new setting.
2.3 3D Video Mode Setup
The camera’s 3D-mode can be selected between squeezed side-by-side 3D (factory default) and
field-sequential 3D, both with normal (factory default) and swapped images. The 3D-mode can be
changed by executing the following procedure, which can be canceled at any time by power-
cycling the camera.
Power off camera.
Press push button 2 and keep it pressed.
Page 5 of 12
Subject to change without notice.
EN
