NanoCam3D Mk.1 Instruction Manual
IMPORTANT – READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
1 Introduction and Designated Use
NanoCam3D Mk.1 is a stereoscopic FPV camera for radio-controlled vehicles, in particular for
micro quad-copters. The camera is delivered in a pre-calibrated and ready-to-use state. The
factory settings of the camera are:
Video norm: PAL,
3D-Mode: Squeezed Side-by-Side 3D,
Image swap: No swap,
Auto exposure algorithm: Average Brightness Tracking.
These settings provide compatibility with most of the currently available 3D-capable FPV goggles
like FatShark Dominator HD V1-V3 and Dominator V3; Zeiss Cinemizer, Cinemizer Plus and
Cinemizer OLED as well as AOMWAY Commander V1. Users of FatShark Attitude V3 or Headplay
PCS video goggles (with Field-Sequential 3D support) should refer to chapter 2.3 for video setup.
The following picture shows all camera connectors and data ports.
Figure 1: Camera front and rear side
The JTAG port is used for device programming and typically not of interest for operational use. The
serial port with auxiliary 3.3V supply connects the camera to future devices, e.g. for generation of a
stereoscopic on-screen display (3D-OSD).
Page 3 of 12
Subject to change without notice.
EN
