STACIS
2100 Piezoelectric Isolation System - Installation & Operation Manual
P/N 96-28765-01
Page 42 of 43
8 Appendix B: Using TMC Analyzer to Collect and Upload Data
Follow the procedure below:
A. Connect a DB9 serial cable between the computer and the COM 1 port located on the controller’s
front panel.
B. Set the controller LCD menu to
System Diagnostics
Upload Data to PC
Run PC Program TMC
Analyzer
(see illustration below).
Press the
PREVIOUS
switch on the controller’s front panel repeatedly
until the following
message is seen on the LCD:
T M C S T A C I S 2 1 0 0
p n 9 5 - 2 8 7 5 6 - 0 1 R e v #
Press the “
+
” switch repeatedly until the LCD shows:
+ / - S e l e c t s F u n c t i o n :
S y s t e m D i a g n o s t i c s
Press the “
SELECT
” switch, and then press the “
+
” switch repeatedly until the LCD shows:
- / +
M o d e S E L E C T
R u n
U p l o a d D a t a t o P C
Press the “
SELECT
” switch. The LCD will now show:
R u n P C P r o g r a m
T M C A n a l y z e r
C. Launch the TMC analyzer application Analyzer.exe. A screen similar to the one below will display.
Step D
Note:
Click on
Stop test
to stop
at any time
Step E
Step G
Step F
If not already installed on your computer, install the
TMC Analyzer
application by running the
Setup.exe file from the “TMC_Analyzer 1.xx install” folder. Contact TMC Service for a copy of
the application, if necessary.
