TLS TLS430FDCEx1 Series, Installation, Operation & Service Parts Manual

Page: 10 / 43

10
Bay Entrance Door
FRONT
Work Stands
for runway
placement
Left Side
(driver side)
Right Side
(passenger side)
Powerpack
Column
column locations
column locations
INSTALLATION PROCEDURE
Insure the lift installation complies with ANSI/ALI/ALIS, Safety Requirements for Installation
and Service of Automotive Lifts.
1. Remove protective wrapping from the lift and clear installation area of packaging
materials. Place two 4"x4"x 24 " wooden blocks under the lift to enable fork lift or other
access and to allow for removal of shipping frames. Unbolt steel shipping frames and
remove from installation area. Take adequate precautions when working with runways,
columns and other components.
2. Work stands are recommended
for safety and ease of runway
and carriage assembly. As an
alternative, use wooden blocks
to raise runways off the floor.
Position work stands
(
or wooden
blocks
)
as shown in the diagram
to the right.
3. Identify front crossmember and set it
securely on top of front work stands.
Insure the end with 2 single pulleys is
next to the powerpack
(driver side)
column. Unbolt one of the guide blocks
on each end of the front crossmember.
4. Place one front column into each end of
the front crossmember insuring the
guide blocks are centered in the grooves
of the column walls. (To do this, safety
ladder must be pulled out from the tower
and then put back into the crossmember).
5. Slide the unbolted guide blocks you removed in step 3 down from the top of each column
and bolt back in place on the crossmember ends.
6. Carefully lift rear crossmember and set it securely on top of the rear work stands. Insure
the end with 2 double pulleys is on the same side as the powerpack (driver side) column
and in line with the front crossmember single pulley (see diagram #6 - cable routing).
7. Unbolt one of the guide blocks on each end of the rear crossmember.
8. Place one rear column into each end of the rear crossmember insuring the guide blocks
are centered in the grooves of the column walls.
9. Slide the unbolted guide blocks you removed in step #7 down from the top of each
column and bolt back in place on the crossmember ends.
10. Carefully lift the left (driver side) runway and set it securely on top of both front and rear