Care and maintenance
TTB579PLN
by TITAN
32
In
more
detail…
GB
IE
Caution:
This operation should only be carried out by a suitably
qualified person.
NOTE:
Once this operation is complete, ensure that the cutter-
block turns freely by hand before re-connecting the machine to the
mains supply. Replace all safety guards immediately after
completing this operation.
Fig. 42
Fig. 41
Fig. 40
> Fit the blade correctly into the clamping device.
> Slide both components into the cutter-block, taking care that they are fitted in
the correct direction etc.
> Centre the blade assembly laterally.
> Set the blade setting block (40) over the cutterblock.
> Pull the setting block back so that it sits firmly against the front edge of the planing
out-feed table.
> Put firm downward pressure on the setting block whilst keeping it firmly against
the edge of the out-feed table. This will push the blade into place.
> Keep firm pressure on the setting block and tighten the 5 blade tensioning screws.
> Once complete, turn the cutter-block to expose the 2nd blade and repeat the
process to replace that blade.
2) Fitting the blades
> Carefully turn the planer thicknesser onto its side.
> This will expose the motor of the machine.
> Take a slotted screwdriver (not supplied) and locate it in the slot on the motor
brush cap.
Replacing the motor brushes
40
