Care and maintenance
TTB579PLN
by TITAN
30
In
more
detail…
GB
IE
Fig. 33
Fig. 34
Fig. 35
Fig. 36
The positive stops at 90° and 45° are set at the factory to ensure accuracy, however
over time they may need to be reset.
> Loosen the fence angle lock handle (20).
> Sit a 90° square firmly on the planer table.
> Set the guide fence against the square, this will give an angle of 90° between
the bed and the fence.
> Loosen the lock nut (j).
> Tighten / loosen the angle locking bolt until it sits against the angle stop on the
angle guide (19), whilst ensuring that the 90° angle is kept.
> Re-tighten the lock nut to hold the bolt securely in place.
> Loosen the angle pointer screw (k) and set the angle pointer so that it reads 90°.
> To set the 45° positive stop, set the guide fence so that the angle pointer is at
45°.
> Loosen the 45° lock nut (l).
> Tighten / loosen the angle locking bolt until it sits against the 45° stop on the
angle guide.
> Re-tighten the locking nut to secure.
Setting the positive stops on the
guide fence
38
18
j
l
17
16
k
20
19
