Titan TTB426GDO, Operating Manual

Page: 22 / 32

1. SERVICE AND STORAGE
To ensure long and reliable service, carry out the following
maintenance regularly. Servicing and cleaning work on the
pruner and the removal of the guards may only be carried
out after the motor has been switched off and the plug
disconnected from the power supply.
1). Regularly check for obvious defects such as loose,
dislodged or damaged chain and guide bar, loose
fixings and worn or damaged components.
2). Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance
or repairs before using the pruner.
3). If the saw chain should happen to fail despite the care
taken in manufacturing and testing, repair
should be carried out by an authorized specialist.
4). Do not clean the pruner while it is running.
5). Ensure that all the fastening elements (screws, nuts,
etc.) are tight at all times so that you can safely work with
the pruner.
6). Check the pruner frequently for signs of wear. Replace
worn or damaged parts.
7). Store your pruner in a dry place. To ensure a long
service life all screw parts should be cleaned and then oiled.
8). Clean the pruner with a brush or cloth. Do not use any
solvents or water to remove dirt.
9). The component that is subject to most wear is the saw
chain. You should therefore check the condition of the saw
chain and its mounting at regular intervals.
- If the saw chain is worn or blunt it must be replaced or
sharpened immediately;
- If the pruner starts to suffer from excessive vibrations,
this means that the saw chain or guide bar has not been
balanced correctly or has suffered deformation due to
impacts. In this case it must be repaired or replaced.
MAINTENANCE
WARNING!
Before carrying out any repairs or
servicing work, you must ensure that the pruner
has been disconnected from the power supply. Repairs
and maintenance work other than described within this
instruction manual may be performed only by qualified
specialist!