Titan TTB426GDO, Operating Manual, Page: 16 / 32

Chain ‘tie straps’
a). Set the power tool on a suitable flat surface.
b). Use the screwdriver end of the multi tool to turn the chain
tension screw in a clockwise direction until the chain “tie
straps” are just touching the bottom edge of the guide bar.
The correct chain tension is reached when the chain can be
lifted by approx. 2-4 mm from the chain bar in the centre.
This should be done by using one hand to lift the chain
against the weight of the machine. (See Fig.6a & 6b)
B
The oil tank holds 60mI chain lubrication oil, enough to
lubricate the chain for 20-25 minutes of cutting.
The oil tank level can be checked by way of the oil level
gauge (B). Check oil level gauge prior to start-up and
regularly during operation. Refill oil when oil level is lower
than "MIN" marking. (See Fig.7)
a). Set pruner on any suitable surface with oil tank cap (13)
facing upward.
b). Clean area around the oil tank cap with cloth.
c). Add chain lubrication oil until reservoir is full. You can
use either SAE30 or SAE10.
d). Avoid dirt or debris entering oil tank, refit oil filler cap and
tighten.
Fig. 6a
Fig. 6b
3). CHAIN AND BAR LUBRICATION
WARNING! The pruner is not filled with oil. It is
essential to fill with oil before using.
Never operate the pruner without chain oil or an empty oil
tank, as this will result in extensive damage to the product.
WARNING! Never run the bar and chain without
lubrication oil. Running the saw dry or with too little oil
will decrease cutting efficiency, shorten chain saw life, and
cause rapid wear to the chain and bar from overheating.
Insufficient oil is evidenced by smoke or bar discoloration.
Adequate lubrication of the saw chain during cutting
operations is essential to minimize friction with the guide
bar. Your pruner is equipped with an automatic oiling
system. The oiling system automatically delivers the proper
amount of oil to the bar and chain.
Fig. 7