4
WARNINGS TO THE CUSTOMER ON SAFE OPERATION
OF THE TURNSTILE
These warnings are designed for ensuring of safety during operation of the turnstile to
prevent violation of safety characteristics by improper installation or operation. These warnings
are aimed at drawing attention of the customer to safety problems.
GENERAL WARNINGS
The Operation Manual is an integral part of the product and it should be handed over to the
customer. The OM should be kept for later use and consulted for clarifications if required. If the
turnstile is resold, handed over to another owner or transported to another place, make sure that
the OM is enclosed to the turnstile to be used by new owner and/or maintenance staff during
installation and/or operation.
Safety measures and requirements specified in this in this OM must be observed:
–
the turnstile must be connected to ground loop prior to operation;
–
the turnstile should be connected to AC network with parameters specified in p.1.2
"Specifications";
–
inspection, adjustment and repair should be performed only after the turnstile is
deenergized.
After the turnstile is purchased it should be unpacked and its integrity should be checked. In
case of doubt in integrity of the turnstile it should not be used and the customer shall refer to the
supplier or to the manufacturer.
Packing accessories (wooden pallet, nails, clips, polyethylene bags, cardboard etc.) as
potential sources of hazard must be removed to unacceptable place prior to proper use of the
turnstile.
As electric shock protection device the turnstile is related to 01 protection class according to
the GOST (State Standard) 12.2.007.0-75 and is not intended for operation in explosive and fire-
hazardous areas by the “Electrical Installation Code”.
Using of the turnstile for unintended purpose, improper installation, nonobservance of
conditions of transportation, storage, installation and operation specified by this OM, may result in
damage to people, animals or property for which the manufacturer is not responsible.
