21
E
N
G
L
I
S
H
5. Position battery wires around the posts as shown (Figure 22) so wires are not pinched
or sheared when the left Receiver half is replaced.
6. Replace the left Receiver half and secure with Screws (32 and 34, Figure 20).
7. Reinstall the battery door, see instructions (page 11).
8. Reinstall the trigger assembly into the lower Receiver.
9. Insert the Selector Switch into the left side of the lower Receiver.
10. Put the ASA onto lower Receiver and align the mounting holes. Insert the ASA bolts,
with the short ASA bolt in the front position.
11. If applicable, attach the Gasline to the front of the E-Grip ASA.
Assemble Lower Receiver to Upper Receiver
Check to be certain the Trigger plates have not separated, and the Trigger assembly is intact
as shown. If you notice gaps at (D) between the Trigger Plates (A) and the Trigger (B) or the
Sear (C), squeeze the plates together so the assembly appears as shown (Figure 23).
For the Response Trigger markers, put a couple drops of marker oil onto the Cylinder Fitting
O-Ring located in the lower Receiver (Figure 26).
For Response Trigger equipped markers, push the
lower Receiver straight up until Push Pin holes are
aligned. Pay particular attention that the Cylinder Fitting
goes straight into the Interior Flow Connector Fitting
(dark arrow, Figure 26). Insert two Push Pins (44) to
secure.
For non-Response Trigger markers, line up the lower Receiver front
Push Pin holes with the upper Receiver holes, then gently rock rear of
grip until you can insert two Push Pins (44) to secure.
Figure 21: E-Grip Internal Parts Diagram
TA01019 Lower Receiver Right
TA01018
Lower
Receiver
Left
TA10066
Battery Door
TA02061 Air Supply
Adapter (ASA)
CA-08B
Adapter
Nuts
TA99500 Electronics Assembly
Frame Half - Right
Armature
Spacer
Electronics Board
Frame
Half - Left
TA07074 ASA
Bolt (Short)
98-01B ASA
Bolt (Long)
Figure 22: Electronics in lower Receiver
Electronics
Trigger
Guard
Route
Wires
as
shown
Armature
and
Spacer
ASA
Nuts
Figure 23: E-Grip Trigger Assembly
Figure 24: Final
assembly
44
44
