Tion O2 Lite, User Manual, Page: 24 / 36

24 Compact Ventilation Unit
5.4.2 Connecting the device to the MagicAir system
To use the device with the MagicAir system, first connect the device to it. Only
devices with the designated interface unit can be connected to Magic Air.
To connect the device to the MagicAir base station simultaneously press the [+]
and [SET] buttons on the device panel and hold for 2 s. The LCD will blink during the
connection process. After a successful connect, a single beep will sound. The connec-
tion process takes at most 30 s. In the case of a connection failure, a double warning
beep is issued.
After a successful connect, the MagicAir logo will be displayed (section 5.3.1).
Once the device is connected, the time adjustment is disabled from the panel (time
settings are then taken from the MagicAir system).
5.4.3 Control modes
After connection to the MagicAir system you can use either manual or automatic
operating mode. The automatic mode can be switched on using the designated mobile
application MagicAir and via the web interface on the site magicair.tion.ru, by moving a
slider. In the automatic control mode, its icon is indicated on the LCD (section 5.3.1).
In the automatic mode you can control the maximum/minimum fan speed, switch
the heater on/off and set the heating temperature.
For manual adjustment of the fan speed, timer, environmental parameters (from
control panel or remote control) first disable the automatic control mode. To do so
press any button (except ) either on the control panel, or on the remote control. The
automatic control mark will disappear from the LCD display.
In the manual control mode you can turn the device on and off, adjust the fan
speed, select the air intake mode, switch heater on/off and set up heating temperature
Switching between manual and auto control modes is performed in the MagicAir
mobile application using the corresponding slider.
6. GETTING STARTED
6.1 Unpacking and Visual Inspection
Remove the transportation packaging and examine the device carefully to make
sure it has no damage caused by improper transportation or storage. If you notice any
damage, consult the service center of your Vendor to decide whether it is safe to use
the device.
If the temperature of the device housing before installation is below 10 °C (after
storage or transportation in cold environment), first keep the device for 2 hours in a
warm room inside the packing film to bring its temperature up to room conditions.
Failure to do so can cause device failure, damage its plastic parts during installation or
lead to condensate formation.