Tion O2 Lite, User Manual, Page: 23 / 36

23
PLEASE NOTE! If the device is left off with closed flap for a prolonged
period of time under negative outdoor air temperatures, it is possible that
working parameters may deviate from nominal values after it is turned on
again, for example with increased noise and decreased performance. To
resume operation in these conditions do the following:
• turn on the power switch on the right side panel of the device;
• wait for the device to warm up to room temperature;
• switch on the device using the button on the control panel or remote
control.
Please note! If a double beep was issued after the power was turned off
(signaling that flap is not completely closed), do the following:
• Disconnect the device from mains supply (pull out the power plug) and
place the device in a warm location inside the room (a certain distance
away from its place of operation);
• wait for device to warm up to room temperature;
• install the device back to the place of operation;
• reconnect the device to the mains supply;
• turn on the power switch on the right side of the device.
5.4 Functioning with MagicAir
5.4.1 About the MagicAir System
The MagicAir base station monitors the CO2 level in a room using a set of desig-
nated sensors. The collected sensor data are sent to a cloud server and can then be
retrieved by smartphone. With the free MagicAir mobile application the user can follow
and control the compatible devices from the internet, at any time and from anywhere.
In accordance with programmed parameters, the MagicAir base station issues com-
mands to the connected climate control units.
By default the Tion О2 MAC and Tion О2 MAC Base Breezers are equipped with an
interface module for connection with the MagicAir system. All other Breezer versions
can be upgraded with this module at any authorized service center of the Manufacturer.
Functioning of Tion О2 Breezer with the MagicAir system:
Transfer the challenge of maintaining an optimal microclimate to an automated sys-
tem. The MagicAir base station collects environmental data and autonomously controls
the Tion О2 Breezer device.
• Control СО2 level in living and office spaces with a mobile application.