Tion O2 Lite, User Manual, Page: 13 / 36

13
Figure 6. LCD display when the device is under manual control and filter replace-
ment schedule is drawing near Error: Reference source not found
Figure 7. LCD display when the device is under automated control of MagicAir sys-
tem (section 5.4), heater is off or not installed in this configuration
Figure 8. LCD display in standby mode (section 5.3.4)
5.3.2 Control Panel Buttons
The command buttons are located on the control panel (Fig. 9). They are used for
controlling the device, switching between standby/operating modes and establishing
communication with the MagicAir base station.
«Power». Switching between standby and
active mode
«[+]». configuration Increase value or ac-
tivate
«[-]». Decrease value or deac-
tivate
«SET». Selection of parame-
ters to be adjusted
Figure 9. Control Panel Buttons