Timken VHIN 10, User Manual

Page: 14 / 252

12 13
5.1. Setting up the work piece where the yoke passes through it
• Make sure that the bright
sides are greased sufficiently
(improve contact, avoid
excessive vibration) and are
aligned on the top of poles.
Correct Incorrect
• Always choose a yoke, which
fills the bore of the bearings as
fully as possible. You can even
combine 2 yokes - this helps to
heat more quickly & evenly.
Correct Incorrect
• For Swing Arm Yokes: Swing out yoke towards the front of the heater
until it falls in the positioning lock of the hinge construction. Slide the
workpiece over the yoke till it lies in the middle of the yoke and swing
the yoke incl. Work piece back on top of the poles.
• Always make sure that the workpiece has no direct contact with the
plastic housing of the heater.
• When heating cycle is ready, follow the above instructions in opposite
order to take of the heated work piece. Wear protective clothing like heat
resistant gloves because the workpiece is hot now. (Supplied gloves are
suitable for 150°C (302°F).
• Always treat yokes carefully falling, jolting, etc, can damage them.
Always put the yoke away immediately after use
noticeheaterGB.indd 12 17/10/06 15:17:00