Timberwolf TW 230VTR, Instruction Manual

Page: 36 / 68

TW 230VTR
34 / 65
V-BELT TENSIONING TABLE
C190-0113 01.07.2019 Rev: 4.0
Method:
Set the deflection distance on the lower scale of the tension gauge so that the underside of the 'o'-ring equals the 1
'h' value given in the table.
Ensure that the deflection force scale is zero'd by pushing the upper 'o'-ring all the way down. 2
Place the tension gauge in the centre of the belt span as shown in the diagram. 3
Press downwards on the rubber buffer, deflecting the belt until the underside of the lower 'o'-ring is level with the 4
belt behind (use a straight edge if there is only 1 belt).
Take the reading from the deflection scale of the tension meter (read at the lower edge of the 'o'-ring) & 5
compare this value with that given in the table.
Tighten or loosen belts as required following procedure given in this operator's manual. 6
Tension gauges are available from Timberwolf spares, quoting part no. 18091
Rotor
Pulley
Engine Pulley
Belt
Tensioner
Engine
Pulley
Pump
Pulley
ROTOR BELTS
PUMP BELTS
Tips on belt tightening:
There will normally be a rapid drop in tension during •
the run-in period for new belts. When new belts are
fitted, check the tension every 2-3 hours & adjust
until the tension remains constant.
The best tension for V-belt drives is the lowest •
tension at which the belts do not slip or ratchet
under the highest load condition.
Too much tension shortens belt & bearing life. •
Too little tension will affect the performance of your •
machine especially in respect of no-stress devices.
Ensure that belt drives are kept free of any foreign •
materials.
If a belt slips - tighten it! •
TW 230VTR Rotor Belts
Pump Belts
Belt Mffr / Type Gates Super HC-MN Quad Power III
Belt Pitch Designation SPA XPA
Belt Length in mm 1232 850
Belt Deflection in mm = h 2.8 2.1
Force Reading (Kg)
New belt 1.9 - 2.1 1.5 - 1.6
Used Belt 1.7 - 1.8 1.3 - 1.4