Timberwolf TW 230VTR, Instruction Manual

Page: 16 / 68

TW 230VTR
14 / 65
OPERATING INSTRUCTIONS
C190-0113 01.07.2019 Rev: 4.0
THE FOLLOWING PAGES DETAIL ONLY BASIC
MAINTENANCE GUIDELINES SPECIFIC TO YOUR CHIPPER.
THIS IS NOT A WORKSHOP MANUAL.
The following guidelines are not exhaustive and do not extend to generally accepted standards of
engineering/mechanical maintenance that should be applied to any piece of mechanical equipment and the
chassis to which it is mounted.
Authorised Timberwolf service agents are fully trained in all aspects of total service and maintenance of
Timberwolf wood chippers. You are strongly advised to take your chipper to an authorised agent for all but the
most routine maintenance and checks.
Timberwolf accepts no responsibility for the failure of the owner/user of Timberwolf chippers to recognise
generally accepted standards of engineering/mechanical maintenance and apply them throughout the machine.
The failure to apply generally accepted standards of maintenance, or the performance of inappropriate
maintenance or modifications, may invalidate warranty and/or regulatory compliance, in whole or in part.
Please refer to your authorised Timberwolf service agent for service and maintenance.
Problem Cause Solution Caution - Always ensure appropriate PPE is worn.
Wood chip
ejection
stopped /
limited
Obstructed
discharge
Clear debris from discharge chute.
Ensure machine is off and keys
removed.
Loose drive belts Refer to manual & tension belts guidelines.
Ensure machine is off and keys
removed.
Broken rotor
paddles Inspect paddles, replace broken / missing
paddle. Ensure machine is off and keys
removed. Call engineer for repair.
Rotor does
not turn
Obstructed
discharge
Clear debris from discharge chute.
Ensure machine is off and keys
removed.
Rotor jammed
Inspect & clear infeed funnel, roller box and
rotor housing. Ensure machine is off and keys
removed.
Drive belt issue
Inspect drive belts, replace if required.
Refer to manual & tension belts guidelines. Ensure machine is off and keys
removed.
Slow or not
feeding
Low engine speed
Check & inspect throttle and cable. Check
throttle is set to specified speed. Ensure machine is off and keys
removed.
Infeed rollers
jammed Inspect & clear infeed funnel, roller box and
rotor housing. Ensure machine is off and keys
removed.
Hydraulic oil
Check hydraulic oil level, top up if
necessary. Ensure machine is off, cool & pressure
isn’t present within the system.
Blades dull Rotate, sharpen or replace blades.
Ensure machine is off and keys
removed.
Anvils dull
Check anvil has sharp edge, rotate, sharpen
or replace if necessary. Ensure machine is off and keys
removed.
Obstructed
discharge
Clear debris from discharge chute.
Ensure machine is off and keys
removed.
TROUBLESHOOTING
This table is a troubleshooting guide to common problems.
If your problem is not listed below, or is unresolved after following the guide, please contact your Timberwolf service
agent, whose Timberwolf trained engineers can perform further fault finding. Before you call, please have this operating
manual and the machine serial number ready.