Timberwolf TW 230VTR, Instruction Manual

Page: 27 / 68

25 / 65
SERVICE INSTRUCTIONS
C190-0113 01.07.2019 Rev: 4.0
TW 230VTR
Check that the grease contained in the hydraulic 1
cylinder has been removed.
Mesh the track links in the sprocket and place the other 2
end of the track on the track-stretching wheel.
Locate the track on the stretching wheel using levers if 3
required.
Make sure track links mesh correctly in the sprocket 4
and in the track stretching wheel.
Adjust track tension (see track loosening procedures on 5
page 24).
Set the tracked undercarriage on the ground. 6
CHECKING SPROCKET WEAR
Measuring wear on sprocket and driving gear teeth is one
of the most difficult measurements to be done. You must
always consider the point where wear is greatest.
There should always be enough tooth left on the sprocket
to engage fully with the rubber track. When the sprocket
meshing distance is reduced significantly the sprocket
should be changed.
INSTALLING THE RUBBER TRACKS
Stretching wheel end
Drive sprocket end
WARNING
MAKE SURE THAT YOU ARE ALWAYS IN
SAFE CONDITIONS WITH THE MACHINE
LIFTED TO PERFORM THE OPERATION
FOR TRACK INSTALLING.