3-4
2GX/AERO X Owner’s Manual
OM0002_Rev A_2GX/AERO X
CHAPTER 3: FOOTRESTS
High Mount Flip-Up Footrest; Angle Adjustable High Mount Flip-Up Footrest; Depth
Adjustable High Mount Flip-Up Footrest; and Depth and Angle Adjustable High Mount
Flip-Up Footrest
Note:
Dependent upon the seat to footrest measurement, your swing away high mount footrest may be assembled with
the extension tube positioned inside the hanger. See Figure 3-2. If so, follow the procedures under “Adjusting the Height/
Replacing” on pages 3-1 and 3-2.
If you are unsure which type of High Mount Flip-Up Footrest is installed on your chair, see Figure 3-7.
Note:
If your chair has 90º hangers, see “90º Hanger Flip-Up Footrests; 90º Hanger Depth Adjustable Flip-Up Footrests” on
page 3-5 or “90º Hanger Depth and Angle Adjustable Flip-Up Footrests” on page 3-6.
Figure 3-7
High Mount Flip-Up Footrest
High Mount
Angle Adjustable
Depth Adjustable
Depth & Angle
Adjustable
Adjusting the Height/Replacing
Tools Needed:
• 3/16” Allen Wrench
• Ruler
1. Loosen the two Allen screws through the binder clamp that secures the extension tube to the frame. See Figure 3-8.
2. Raise or lower the extension tube to the desired height (not less than 2” of ground clearance).
3. If replacing the entire footrest assembly, remove the extension tube and flip-up footrest assembly completely and
reattach a new extension tube and footrest assembly at the desired height (not less than 2” of ground clearance).
4. When both of the footrests on both sides of the chair are adjusted to the desired height, securely tighten the two Allen
screws through the binder clamp that secures the extension tube to the frame.
Figure 3-8
Height Adjustments on High Mount Flip-Up Footrest
Binder Clamp
Extension Tube
Frame
Allen
Screws
