ThyssenKrupp gulliver, User Manual

Page: 15 / 24

04/03/2015 Orion - Gulliver User Manual
15
5 Light maintenance
The THYSSENKRUPP ENCASA S.R.L. Platform Lift only requires the owner to perform simple
maintenance operations.
It is advisable to keep the rubber-coated load surface clean; it can be washed with common
detergents for rubber; after cleaning, dry the load surface thoroughly before using the Platform Lift
again.
If the walls of the cabin or of the protective panel are in plasticized sheet-metal, they should be
cleaned with neutral detergents and water. Chemical solvents should never be used for any reason
whatsoever as they could damage the material. Dry thoroughly after cleaning.
If the Platform lift is equipped with a "cabin", the cleaning of the walls should be done as described
in the previous points. Choose the detergent to be used based on the type of wall covering material.
Dry thoroughly after cleaning.
The floor doors are in varnished metal, like the shaft (in those versions where it has been provided.)
Such parts can be cleaned by using water and normal detergents for domestic use. Chemical
solvents should not be used for any reason whatsoever as they could damage the material. Dry
thoroughly after cleaning. Use the same procedure for any glass parts if present.
Check for oil leaks around the hydraulic control panel. If any leaks are found, contact maintenance
personnel.
If the Platform Lift’s alarm should be set off and you wish to silence the warning signal while waiting
for maintenance personnel to arrive, disconnect the Platform Lift’s electrical supply as described.
6 Maintenance
A maintenance contract, in accordance with the Italian Presidential Decree no. 459 and Ministerial
Memorandum no. 157296 dated 14/04/1997, must be stipulated with a service company which
has been approved by THYSSENKRUPP ENCASA for all operations which the user cannot carry out.
Regular maintenance of the Platform Lift, including at least two annual overhauls, will guarantee the
continued efficiency of all of the parts which make up the Platform Lift and is indispensable for its
safe and proper function.
Before performing any maintenance operations upon the Platform Lift, switch it off by
turning the electrical panel’s main switch to the 0 (zero) position. Reactivate the Platform Lift
once the maintenance operations have been completed.
7 Internal lighting
The internal part of the Platform Lift is lit by a ceiling lamp (in configurations equipped with a
protective panel) or by two spot lights (in configurations with cabin, protective panel and canopy).
The light goes out automatically, if the platform stops at a floor, within a pre-set time of 30 seconds,
if no command buttons are pressed or if a door is not opened.
In the case of the ELEGANCE version, illumination is guaranteed by four halogen spot lamps, or else
by a fluorescent bulb system, in the case of a false ceiling or by a matrix of LEDs.