USERS MANUAL MINI 60
D ONGGUAN T HUNDER L ASER E QUIPMENT C O.,LTD
S hatian To wn, S h atian Da dao, M intian
Tel :(86)769 826653
Do ngguan C i ty, G uangdong P r ovince, China
16
Chapter 3. Process of Installing
3.1 Unpacking
You receive your THUNDER LASER MINI60 SERIES packed in a wooden box which
contains the laser machine and additional accessories. The following steps give you an
overview of the unpacking and assembly of the laser. Please follow these steps carefully.
Keep the packing box. You will require it in case of a return.
Dispose all waste according to the applicable waste disposal law.
1. Put the wooden box on a flat and spacious room for unpacking.
2. Remove the machine box; carefully remove the protective foam, wraps, films, etc…
3. Open the door of the laser, remove the accessories box which contains all accessory
parts required for the installation of the laser machine and check the contents carefully.
4. You will see an attachment table on the machine; please check whether the accessories
are all on the table.
5. Please keep the warranty certificate as well as the model and serial number of the
machine. If you need tech support we may ask you for this information.
6. Remove the sponges and nylon cable ties from inside the machine, and then start to
install the machine, carefully following the instructions in this manual.
3.2 Location
Before you install the laser system, you should select an appropriate location. Follow the
guidelines shown below:
1. Avoid locations where the system is exposed to high temperatures,
dust and high humidity. (The humidity must not exceed 70% and the
temperature must not be close to the dew point.)
2. Avoid locations, where the system is exposed to mechanical shocks.
