Thump TSK50cc, Owner'S Manual

Page: 9 / 132

5
□
Check oil level with bike in upright position using dipstick
(page 46)
□
Check throttle is working correctly with freeplay adjusted correctly
(page 57)
□
Ensure wheel spokes are tight & wheels run true
(page 70)
□
Inspect bike for any other defects
□
Start engine & warm up (using choke if necessary). Set idle speed so
engine ticks over comfortably without stalling or racing.
(page 61)
□
Test machine ensuring that all controls are fluid & functional. Ensure
brakes are working efficiently (bearing in mind that the pads will need to
bed in prior to optimum performance).
Engine break-in
Run bike at no more than three quarter throttle & do not allow engine to
rev to a high speed. Engine break-in should be no less than one hour.
After one hours carry out the following checks & procedures:
□
Drain oil & replace with 950mls quality 10w 30w or 10w 40 4-stroke
engine oil
(page 47)
□
Check all nuts & bolts & tighten where necessary
(page 119)
□
Check wheel spokes (especially rear wheel drive side) & tighten where
necessary
□
Re-Adjust throttle cable if required
(page 56)
□
Re-tension chain and lubricate
□
Check wheel bearings for any sign of wear of free-play
□
Check brake calliper operation & brake pad wear
(page 67)
□
Check tire pressures
(page 74)
Remember to do pre-ride inspection each time you ride
(page 24)
Motorcycle Assembly