GLASSWARE SANITIZING APPLIANCE
User and maintenance manual
REV. 4
5
EN
GLI
SH
1. GENERAL INFORMATION
1.1. QUICK START
To start the machine carry out the following:
1) Unpack the machine, retaining the packaging for any future shipment;
2) Install the machine on a flat surface;
3) Place the CO2 cylinder in a place away from and protected from heat;
4) Connect the CO2 cylinder to the solenoid valve, as described in section 5.2 of this manual
and open the cylinder valve;
5) Connect the charger to the existing outlet on the appliance (see figure at centre of page 13);
6) Connect the charger to a power outlet with a voltage between 100 and 240 Vac and leave
to charge for between 8 and 16 hours;
7) When fully-charged, disconnect the charger from the outlet and then from the appliance
and store it in a dry place;
8) Turn on the machine and run on an empty cycle to clean the machine; please note that
this stage may be accompanied by the emission of certain odours resulting from material
residues from the packaging;
9) At the end of the cycle, turn off the machine using the appropriate switch.
IMPORTANT NOTE: It is essential that you read all parts of this manual fully and thoroughly
before operating the machine.
1.2. MODELS
Power switch for
the Thrill Vortex SBI built-in
model
1) Thrill Vortex F1- Pro
2) Thrill Vortex SBI built-in model
Summary of Contents for CUBE
Page 43: ......
