Thornhill Medical MOVES SLC, Operator'S Manual, Page: 288 / 362

MOVES
®
SLC™ Operator’s Manual
Thornhill Research Inc.
274
Alarm / Message
Priority Locked /
Latching
Inhibitable
Causes Action(s)
100. NIBP set to:
Manual update Low Locked &
Latching Inhibitable NIBP measurement was not
obtained three consecutive
times when set to take
automatic measurements. 1. Attempt another NIBP reading.
2. Ensure NIBP patient arm cuff is
full connected to MOVES
®
SLC™
and has no leaks.
3. Replace NIBP patient arm cuff.
4. Power cycle MOVES
®
SLC™.
5. Return MOVES
®
SLC™ for
servicing.
101. NIBP fault Low NIBP module internal fault or
NIBP module communication
failure with patient monitor.
1. Power cycle MOVES
®
SLC™.
2. Attempt another NIBP reading.
3. Return MOVES
®
SLC™ for
servicing.
102. NIBP Mode
changed
STAT -> 5 min Low Locked &
Latching NIBP has been set to STAT
mode for 15 minutes and has
automatically changed to take
readings every 5 minutes for
long term monitoring. 1. No action required. NIBP mode
setting can be changed back to
STAT at any time if required.
103. IP zero required Low Inhibitable
(Can be set
by
System
Administra-
tor.
to not be
inhibitable)
At least one invasive channel
has the following set of
conditions:
a) invasive channel is
connected
b) zero is required
c) channel not currently
zeroing
d) zero failed is not
active on the channel
1. Zero all invasive channels which
require zeroing or disconnect IP
cable(s) if not in use.
2. Fully disconnect then reconnect IP
patient connection and zero IP
transducer as prompted.
3. Replace IP patient connection.
4. Check integrity of interface with
patient.
5. Power cycle MOVES
®
SLC™.
6. Return MOVES
®
SLC™ for
servicing.