To place an alignment point, double-left-click it first on the base and then on
the second model. Specify a minimum of three alignment points.
Double-click a point to remove it. Press and hold CTRL key and move a point
to relocate it.
If you like the result which you see in the result window, click
Alignment by
points.
Further actions are similar to 3D model assembling in automatic alignment
mode.
Additional Processing Tools
Raw Data Processing
Raw data is presented in the program as a list of textural and geometric frames.
When selecting one or more frames, you can see the respective raw data which
can be edited using tools on the left panel or deleted. These tools are availa-
ble to correct issues that might have occurred during scanning. For example,
when scanning a human being, even a small difference in facial expression can
lead to a blurred texture or geometry divergence. In this case, bad frames can
be deleted or the face area can be cut out from them.
In the example below geometry divergence can be observed; the scanned
model shows splitting of the surface of the leg.
To search for bad frames, use data visualization. Click the frame in the tree,
press Shift, then press the up or down arrows to highlight new frames.
Frames can also be highlighted by rotating the mouse wheel. In the visual-
ization window, you will see a cloud of points to which subsequent frames
will be added each time. Thereby, once bad frames have been highlighted
this can be seen.
48
Software manual
48
Summary of Contents for Calibry
