8
Installation (Continued)
Step 3: Attach Flue Riser
1.
Place the flue riser assembly on the range as shown on the appropriate diagram below.
2.
Slide the flue riser assembly over the bayonets until it bottom out, as shown below.
3.
Secure ends of flue riser assembly with two M6 hex head bolts, flat washers and lock-washers
Single-Oven Models
Location
1.
Installation must allow for a sufficient flow of fresh air for the combustion air supply.
2.
Installation must include adequate ventilation means, to prevent dangerous build-up of combustion
products.
3.
Any gas burning appliance requires adequate clearance and ventilation for optimum and trouble-free
operation. The minimum installation clearances shown below are to be adhered to.
4.
Position the appliance in its approximate working position.
5.
All air for burner combustion is supplied from underneath the unit. The legs must always be fitted
and no obstructions placed on the underside or around the base of the unit, as obstructions will
cause incorrect operation and / or failure of the appliance.
6.
Components having adjustments protected by manufacturer are only allowed to be adjusted by an
authorized service agent. They are not to be adjusted by the installation person.
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Combustible Surface
Non Combustible Surface
Left / Right Hand Side
Rear
355mm
250mm
0mm
0mm
Assembly
NOTE:
• This appliance is assembled before delivery except feet.
• This appliance is fitted with adjustable feet to enable the appliance to be positioned securely and
level. This should be carried out on completion of the gas connection. Refer to the ‘Gas
Connection’ section.
• IM will be stated that the appliance shall be installed in such a way that side body surfaces are not
accessible in the installed position.
Summary of Contents for TR-0-G24F
Page 26: ...Explosion drawing 25...
Page 31: ......
