22
Troubleshooting (Continued)
THERMOSTAT GRIDDLE
TROUBLESHOOTING
Remove the knobs and control panel.
CAUTION!
WIRING BEHIND THE
PANEL.
Be sure the thermostat bulbs are pushed
completely into tubes under the griddle.
Put the bezels and knobs on the griddle
thermostats.
Set the griddle thermostats to 300F (150
℃
)
Observe the burners while heating griddle
for poor operation.
Refer to burner troubleshooting
After griddle has heated for approximately
20minutes, observe that the flame has
decreased in height.
Set the griddle knobs to the midpoint
between the two lines just after the OFF
position
This is the bypass setting.
Check that there is a 6mm, flame at each
port.
If the flame is not correct remove the knobs and
bezel..
There is a slotted screw below the stem on the
thermostat valve.
Turn the screw counter clockwise to establish or
increase the flame.
If no flame is established put a soap and water
mix to the orifice of the burner to check for gas
flow.
If gas is flowing turn the bypass screw until
flame is set to specifications.
If no flame is established at the bypass setting
replace the thermostat.
Remove the knobs and bezel and install the
control panel.
Reinstall the bezels and push out the silver
center of the knob from the rear of the knob and
reinstall.
Set the temperature to 300F
°
(150
℃
) and allow
the griddle to reheat.
Continues on Next Page.
Summary of Contents for TR-0-G24F
Page 26: ...Explosion drawing 25...
Page 31: ......
