TSC 80 TRANSFER SWITCH CONTROLLER
PM063 Rev 7 09/02/27
Thomson Technology
2
1.2.
GENERAL INFORMATION
The following information is provided for general information only pertaining to TSC 80
transfer switch controllers. For information on the TSC 80e controller refer to product manual
PM091.
NOTE:
Installations should be done in accordance
with all applicable electrical regulation
codes as required.
The following information is provided for general information only pertaining to TSC 80
transfer switch controllers installed in a Thomson Technology Automatic Transfer
Switch as applied in a typical site installation. For specific site installation information,
consult Thomson Technology as required.
CAUTION
contents subject to damage by
STATIC ELECTRICITY
This equipment contains static-sensitive parts. Please observe the following anti-static
precautions at all times when handling this equipment. Failure to observe these
precautions may cause equipment failure and/or damage.
•
Discharge body static charge before handling the equipment (contact a grounded
surface and maintain contact while handling the equipment, a grounded wrist strap
can/should also be utilized).
•
Do not touch any components on the printed circuit board with your hands or any
other conductive equipment.
•
Do not place the equipment on or near materials such as Styrofoam, plastic and
vinyl. Place the equipment on grounded surfaces and only use an anti-static bag
for transporting the equipment.
Summary of Contents for TSC 80
Page 2: ......