THOMSON TG797, Setup And User Manual

Page: 39 / 88

E-DOC-CTC-20080421-0018 v1.0
33
5 Telephony
5.2 Connecting a DECT Phone to Your Thomson Gateway
Introduction
The Thomson Gateway is equipped with a DECT base station allowing you to connect up to five DECT
phones. Before you can start using your DECT phone, you first have to register it to your Thomson Gateway.
Once registered you will be able to make phone calls over the traditional (PSTN) phone network (if enabled
by your telephone operator) or using VoIP (if configured).
Procedure
Proceed as follows:
1 On the Thomson Gateway base station, press the DECT button until the DECT LED on the front panel
starts flashing.
2 Register your DECT phone. If you are using:
A Thomson DECT phone proceed with “ Registering your Thomson DECT phone” on page 33 .
Another DECT phone, consult your DECT phone user documentation to register your DECT phone.
Registering your Thomson DECT phone
On the Thomson DECT phone:
1 Select Menu .
2 Navigate to Settings and press OK .
3 Select Registration and press OK .
4 Select Register Handset and press OK .
5 Select in the base list the base to store this registration in and press OK .
6 You are prompted to enter the system PIN code of the Thomson Gateway. Enter “0000“(default value)
and press
OK . Your Thomson DECT phone is now searching your Thomson Gateway base station.
7 When the registration was successful, the message “Registered to base x” appears on the screen of your
Thomson DECT phone.
It is possible to register your Thomson DECT phone to up to five different base stations. If a
base in the list is marked with a green dot it is already used to store a specific registration with
a base station. If not marked it is empty and can be used for a registration with a new base
station.