THOMSON SpeedTouch, Configuration Manual

Page: 79 / 110

Chapter 8
PPTP-to-PPPoA relaying
E-DOC-CTC-20051017-0167 v1.0
71
8.1 Configuration Procedure for Relayed PPPoA
Introduction
The relayed PPPoA Packet Service implies nothing more than creating a pvc and
enabling the PPTP service.
Preparatory Steps for
relayed PPPoA
To be able to configure the SpeedTouch™ successfully for the relayed PPPoA
Packet Service, the VPI/VCI value of the Virtual Channel on which the PPPoA
connection service is enabled, must be available.
Configuration procedure
Proceed as follows to configure Relayed PPPoA:
1
Create a phone book entry.
2
Enable the PPTP service.
3
Proceed with the configuration of the PC as described in “8.1.1 Using the
Windows XP Embedded PPP Client” .
Phone book entry 1
Add a new phone book entry with name BrPPPoA_ph, VPI/VCI =8.35.
PPTP service
1
Enable the PPTP service with the following CLI command:
=> atm phonebook add name=BrPPPoA_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
=>service system modify name=PPTP state=enabled