THOMSON SpeedTouch, Configuration Manual, Page: 27 / 110

Chapter 3
Routed Ethernet
E-DOC-CTC-20051017-0167 v1.0
19
3.1 SpeedTouch™ Routed Ethernet Configuration
Preparatory steps for
using Routed Ethernet
To be able to configure the SpeedTouch™ successfully for the Routed Ethernet
Packet Service, the following information must be available:
The VPI/VCI value of the Virtual Channel on which the Ethoa connection
service is enabled.
The encapsulation method (in most - if not all - cases LLC/SNAP).
The IP configuration of the Routed Ethernet interface.
Interface road map
The figure below shows the interfaces which have to be configured for Routed
Ethernet.
PPP
PPPoA
IPoA
iARP
PPPoE IPoE /
IPoEoA
ARP
PPPoE RELAY
Multilink
PPP
EthoA
IP Interface(s)
IP Forwarding
Physical Ports
(Eth, USB, WLAN, BT...) ATM VP/VC
(Over DSL / ATM-F)
ISDN
LoopBack
Ethernet Interface(s)
Bridge
VLAN
ATM Bundle
ATM Interface(s)