THOMSON SpeedTouch, Configuration Manual

Page: 15 / 110

Chapter 1
Introduction
E-DOC-CTC-20051017-0167 v1.0
7
Schematic overview
The figure below shows the SpeedTouch™ interface architecture.
Configuration procedure
The configuration of an interface always exists of following three steps:
1
Creating the interface.
2
Configuring the interface.
3
Attaching the interface to its lower layer interface.
Every packet service consists of the configuration of different interfaces on top of
each other.
In this document interfaces are configured by means of:
The Command Line Interface (CLI)
The Setup Wizard
PPP
PPPoA
IPoA
iARP
PPPoE IPoE /
IPoEoA
ARP
PPPoE RELAY
Multilink
PPP
EthoA
IP Interface(s)
IP Forwarding
Physical Ports
(Eth, USB, WLAN, BT...) ATM VP/VC
(Over DSL / ATM-F)
ISDN
LoopBack
Ethernet Interface(s)
ATM Interface(s)
Bridge
VLAN
ATM Bundle