THOMSON SPEEDTOUCH 605S, Setup And User Manual

Page: 10 / 74

1 SpeedTouch™ Installation
E-SIT-CTC-20030605-0003 v1.0
6
1.2 Setting up the SpeedTouch™
Local network
For Ethernet connectivity you need at least:
•
A computer with installed Ethernet Network Interface Card (NIC) or available
on-board Ethernet port
• If needed, a hub or switch and the necessary connection cables
Ethernet Cables
In the SpeedTouch™605s box, a full wired Cat.5 straight-through RJ45/RJ45 Ethernet
cable, further referred to as LAN cable is included.
You can use LAN cables other than the one provided in the box. However make sure to
use correct connection cables.
Wiring procedure Proceed as follows:
1 Use the included LAN cable to wire your computer's Ethernet port to the
SpeedTouch™605s Ethernet port.
2 Use the included DSL cable to wire the SpeedTouch™605s's Line port to your
telephone wall outlet.
3 Plug the power adapter's coaxial jack into the SpeedTouch™605s DC inlet and
plug the power adapter in a wall outlet.
Note Always check first whether the included power adapter suits the local
power specifications.
More information on
Ethernet wiring
For more information, see the application note “The SpeedTouch™ and Ethernet
Connectivity”.
PC wiring
Once all connections are made, the result should look similar as below: