THOMSON Speedtouch 600 Series, Orientation Manual

Page: 12 / 78

1 SpeedTouch™610 Installation
E-SIT-CTC-20030306-0004 v2.0
8
1.2 SpeedTouch™610 Wiring
Local network
For Ethernet connectivity you need at least:
• A computer with installed Ethernet Network Interface Card (NIC)
•
If needed, a hub or switch and the necessary connection cables
Ethernet Cables
In the SpeedTouch™610 box, a full wired Cat.5 straight-through RJ45/RJ45 Ethernet
cable, further referred to as LAN cable is included.
You can use LAN cables other than the one provided in the box. However make sure to
use correct connection cables.
Wiring procedure Proceed as follows:
1 Use the included LAN cable to wire your computer's Ethernet port to (one of)
the SpeedTouch™610 Ethernet port(s).
2 For local networking, repeat step 1 for each computer.
Note If an additional hub or switch is used, please follow the installation
instructions supplied with the hub or switch.
3 Use the included DSL cable to wire the SpeedTouch™610's Line port to your
telephone wall outlet or distributed filter.
4 Plug the power adapter's coaxial jack into the SpeedTouch™610 DC inlet.
Note Always check first whether the included power adapter suits the local
power specifications.
More information on
Ethernet wiring
For more information, see the application note “The SpeedTouch™ and Ethernet
Connectivity”.
Single PC wiring
Once all connections are made the result should look similar as below: