THOMSON 500014, Manual

Page: 10 / 28

Remove one of the two pivots at the end of the octagonal tube around which the shutter rolls. Remove any
control device or manual lock such as straps, handles, locks, etc. from the shutter.
The motor anchor plate will be placed inside the shutter housing drive plate. Remove all obstacles so that
there is a flat surface. Strengthen if required.
Note the axis of the axle that the motor will replace, then place the motor anchor plate, aligning the axis.
Remove the side plate if required, then mark and drill the holes.
Take care not to damage any components when drilling.
EN
10
d - iNSTALLATiON
30Nm drive kit
for rolliNg shutters aNd bliNds
47mm
58mm
Ø 6mm
Ø 6mm
Ø 8mm
Ø 8mm