THOMSON 500014, Manual

Page: 18 / 28

WARNING: Do not let the shutter move freely
when the end stops have not been correctly set.
1 - PROGRAMMING
To pair the management module and the remote
control:
• On the remote control, press and hold the 'on'
and 'off' buttons for the channel you want to
use (1 to 3) at the same time for 3 seconds.
The LED on the remote control blinks red.
• While the remote control LED is blinking, hold
down the pairing button on the management
module for at least 3 seconds. Pairing is now
complete.
2 - SETTING MOTOR END STOPS
Before using your shutter, it is essential that you
set the upper and lower end stop positions for your
shutter.
WARNING :
• During this step, the shutter may not stop by
itself when it is fully open or closed. Read the
following instructions carefully before adjusting
the settings.
• To set the motor end stops, you will need to
press the motor button. If this button is difficult
to access due to lack of space or proximity
to moving parts, use a narrow tool to safely
press the button.
• To set the end stops, you will need to operate
the shutter briefly. If your shutter is completely
open, begin by setting the lower end stop. If
your shutter is completely closed, begin by
setting the upper end stop.
• If your shutter opens when you ask it to
close and vice versa, pressing briefly on the
management module's pairing button will
invert raising and lowering.
To set the lower end stop (closing):
• Lower the shutter using your remote control,
using the off button ('OFF') on the channel that
you used when pairing.
• Immediately press the motor button: the
shutter stops.
• Press the motor button again. For as long as
you hold this button down, the shutter will
lower. Once the shutter is completely closed,
press the on button ('ON') for the channel that
you used during pairing. The current position
is recorded as the lower end stop and the
configuration is finished.
EN
18
E - CONFiGurATiON
30Nm drive kit
for rolliNg shutters aNd bliNds