16
3. OPERATION
3.1 STARTING INSTRUCTIONS
1. Pre-Starting Inspection
Before starting the Mini-Skid Loader complete the
following inspection:
(1) Check the hydraulic oil level, engine oil level,
engine coolant level and fuel supply.
(2) Check for fuel, oil and hydraulic lines for leaks.
(3) Check lights, battery level and cables.
(4) Inspect tracks, pivot points, mounting pins, nuts
and bolts for possible failure or looseness.
(5) Check all controls are in the neutral position.
(6) Check the condition and operation of all safety
decals and equipment – Ensure all shields and
safety screens are in place. If necessary repair
or replace before starting.
For complete daily servicing refer to Section 4.9.
3. Shut-Off Procedure
(1) Select level ground whenever possible. If you
must park on a slope or incline, position the
machine at right angles to the slope. Lower the
attachment to the ground and block the tracks.
(2) Lower the lift arms and ground the attachment.
(3) Return auxiliary hydraulics to the neutral
position.
(4) Return the throttle control to the idle position. If
the engine is hot, allow it to idle for at least 2
minutes.
(5) Turn the ignition switch to the OFF position
and remove the key.
Do not move any of the
control levers unless
standing with both feet
on the platform and
holding the grip handles.
WARNING
2. Starting Procedure
(1) Set the throttle for idling speed. Avoid
excessive engine speed during warm-up.
(2) Turn the ignition key counter clockwise to
activate the glow plugs. Hold approximately 6
seconds.
(3) Turn the key clockwise to the start position to
engage the starter. Do not crank the starter for
more than 15 seconds. If the engine fails to start
turn the key counter clockwise and pre-heat
again.
(4) Allow the engine to warm up for 5 minutes
before operating. Keep the operator’s area free
of debris. Always drive the loader at speeds
compatible with safety, especially when
operating over rough ground, unfamiliar
terrain, when crossing ditches or when turning.
(5) To restart a warm engine, move throttle control
slightly ahead of idle position and turn ignition
key to “START”.
Ensure that the auxiliary
lever is kept in neutral
when not being used to
avoid power loss and
overheating of
hydraulic oil.
IMPORTANT
Do not crank engine with
starter for more than 15
seconds at a time, as this
will overheat the starter.
IMPORTANT
This engine is equipped
with glow pugs. Do not
use ether or any high
energy fuels to assist
starting.
IMPORTANT
Always let the engine
warm completely before
you begin operation each
day.
IMPORTANT
https://www.tractormanualpdf.info/