Think 3D STORMBEE S20, User Manual

Page: 48 / 102

STORMBEE User Manual – Think 3D BVBA
Version N°1.1, last modified 30/09/2018
34
11. Tap on the FPV video feed window to maximize it. The mission window will now minimize.
Zoom in or out and move the waypoint trajectory so that it is fully visible within the minimized
mission window. That way you can easily keep track of where STORMBEE is on its flight path
at each moment of the flight, and have the enlarged FPV camera view to monitor STORMBEE
’s
surroundings during flight.
12. Verify status elements (flight battery voltage STORMBEE 25V fully charged, tablet battery
charge level…) are all OK. Verify on the GS Pro display that there are a 10 or more GPS satellites
available. Also verify that the RC signal and video signal is of good quality.
NOTE It might take some time for the DJI A3 GPS to acquire a good signal and find its location
on the small window in the corner of the app. In the meantime, the supposed location
of the STORMBEE will be the last location where the DJI A3 GPS had a position lock.
NOTE If the compass status is not good, there might be metal in the ground or some other
electromagnetic emitting source nearby which disturbs the compass. Move the
STORMBEE to another location and verify that the error goes away. If the error persists
or if requested by the DJI app, perform the compass calibration procedure described
in the DJI A3 User Manual. The calibration procedure may also be required when the
pilot observes STORMBEE to be performing small circles during flight when it should
remain in hover (control sticks centred and P-GSP mode active).
CAUTION! If the RC remote control connection is not good, try to move the STORMBEE to another
location. Most interference comes from Wi-Fi routers in the vicinity. Be very cautious
when the signal is poor. The pilot should decide at his/her own discretion whether to
take-off/continue or not/land. If the signal becomes poor during flight, the DJI app will
show a pop-up window to inform the pilot of this.
13. Verify the DJI A3 LED module is blinking green.
14. Ensure that the Lightbridge 2 remote controller is in the correct flight control mode! Pilots can
choose between different flight control modes for which the pitch, roll, yaw and throttle stick
functions are switched around across the two control sticks. The default flight controls mode
is “Mode 2”. You can change the flight control (stick) mode in the general settings (
•••
icon).
WARNING!! Accidentally trying to take-off with the wrong flight control mode will very likely result
in a crash!
15. Remove the foam mirror protection piece.