Think 3D STORMBEE S20, User Manual

Page: 47 / 102

STORMBEE User Manual – Think 3D BVBA
Version N°1.1, last modified 30/09/2018
33
NOTE If the LB2 is powered on and no pilot input is given for some time, the LB2 may start
beeping as a reminder to the pilot to turn it off if the LB2 is no longer required (to
preserve battery level). Just touch the control sticks slightly to stop the beeping.
6. Go to STORMBEE and connect the batteries to their respective power port.
WARNING!! You should shove the battery connector smoothly and completely into the socket on
the top plate of the STORMBEE in one fluent motion. Do not leave it halfway or fumble
about to much when shoving it in the socket. The battery connectors have a capacitor
build-in to prevent sparks from occurring while connecting the battery to STORMBEE.
However, this capacitor can burn through if the connector is not fully and smoothly
shoved into the socket. If this happens the battery will be permanently damaged.
7. Go back to the Lightbridge 2 controller and its tablet. You should now see the DJI A3 controller
name appear in the app on the tablet (left-hand top corner). If not, the USB cable between the
LB2 and the tablet may be wrongly connected or even disconnected. If this is the case, simply
unplug the USB cable from the LB2 and plug it back in again.
8. Verify that the status LED of the LB2 is continuously green. If not, the LB2 might be powered
off, the RC connection signal of poor quality or the DJI A3 and LB2 not paired yet. For the latter
case, refer to the manual of the A3 flight controller for pairing it with a DJI LB2.
9. You should now see the main mission screen of the app and in the right bottom corner a small
window with the camera view of the FPV camera onboard the STORMBEE. The FPV camera is
mounted underneath the front GNSS receiver and is pointing forward.
NOTE It is possible that you do not see the camera live feed yet. The GS Pro app default
settings is showing the feed from a digital camera connected to the HDMI port of the
LB2 air module. However, STORMBEE uses an analogue FPV camera connected to the
AV port of the LB2 air module which reduces latency at the cost of lower image pixel
resolution. Tap on the window and move the top slider from HDMI to AV. In addition,
slide the bottom slider fully left to turn off HDMI completely (100%). If done correctly,
you should now see the camera view of the FPV camera.
10. Visually verify that STORMBEE ’s location is correct on the Google Maps (satellite view)
background.