thermopatch.com
23
6.5 MACHINE SETUP
Press MODE to show choice of JOB SETUP or MACHINE SETUP. Press UP or DOWN button
to select MACHINE SETUP.
1.
Press ENTER and select language. Press UP or DOWN button to select ENGLISH.
2.
Press ENTER and choose the temperature scale. Press UP or DOWN button to select
FAHRENHEIT.
3.
Press ENTER and select feed length unit. Press UP or DOWN button to select INCH.
4.
Press and choose the counter, DC or CC. Press UP or DOWN button to select DC (dai-
ly counter).
Press Enter to save the last setting. JOB SETUP: To run Transfer Roll
Press MODE and select JOB SETUP with UP or DOWN button.
Press ENTER and set temperature at 500 degrees F, or to suit, with UP or DOWN button.
Press ENTER and set Feed Length at 4 inches by pressing UP or DOWN button
Press ENTER and set Print Time at 2 seconds by pressing UP or DOWN button.
Press ENTER and set Seal Only to NO, with the UP or DOWN button.
Press ENTER and set Pattern Marker to YES with the UP or DOWN button.
Press ENTER to save the last setting.
If the Job is using Ribbon (C-Tape), set Pattern Marker to NO. Leave Seal Only set to NO.
Change temperature, feed length, and time to suit.
If the JOB is to seal individual labels, patches, or transfers, set Pattern Marker to NO. Set
Seal Only to
YES, this will disable the roll feed. Set temperature, time, and pressure to suit. Press ENTER
Button after each selection to save the settings.
The machine will automatically exit the menu mode if none of the buttons are pressed with-
in 5 seconds.
