ThermoFLUX EN-B, Installation And Operation Manual

Page: 16 / 68

16
EN
TECHNICAL PASSPORT INSTALLATION and OPERATION MANUAL
Parameter
t
СН
indicates the
value of instantaneous
temperature at upper and bottom part of the buffer
tank.
This screen is active only when has been selected the
menu option for boiler control according to buffer
temperature.
Parameter
t
E
indicates exhaust
gases temperature.
Set maximum
temperature of the boiler
through navigation
arrows. Press button F
and hold for 3 seconds to
set the follow parameters:
Possibility for forced turn on of
ash and soot transport screw.
Time setting of screw
operation. To set start and
operating time use buttons
“ Navigation arrow Up ” and “ Navigation arrow
Down ”. After entering the correct value press button
“ Enter ”.
Use this menu to adjust switch-
on temperature of central
heating pump.
. From this menu you can
preset buffer tank circulation
pump switch-on and switch-
off temperatures provided
such heating installation
scheme (with buffer tank included) is selected,
whereas the two sensors reading these temperatures
are mounted in the upper, respectively lower part of
the buffer tank (cf. boiler connection schemes).
From this menu you can adjust
the maximum temperature in
the domestic hot water storage
tank, whereas by navigating
from the arrow keys up and
down and using the Enter button you can change the
parameters. You can adjust the maximum domestic
hot water temperature inside the storage tank, as
well as the switch-on hysteresis for the circulation
pump after a drop of DHW temperature inside the
storage tank.
Use UP and DOWN arrow keys
in Set Time menu to set the
unit’s built-in timer/clock.
Use UP and DOWN arrow keys
in Set Date menu to set the
date.
Use UP and DOWN arrow keys
in Contrast menu to adjust the
LCD display backlight level.
Confirm settings by shifting to
next submenu through a single
pressing of the functional key F .
Use this menu to choose the
language of the controller.
Choose a language by pressing
navigation arrows and button
“ Enter ”.
10.2.2. Burner start-up „Switch mode“
Burner start-up. After pressing
the “F” button and using the
navigation arrows, the “ Auto ”
or „Standby” menu is selected.
Set the priority mode of the
burner through “navigation
arrows.”
- CH + DHW – Both pumps / CH -central heating
pump and DHW – domestic hot water pump /are
active.
- CH only – In this mode of operation the only active
pump is the CH circulation pump for the heating
installation (CH pump) . In this mode, the boiler
can be managed via a room thermostat or be
temperature-controlled by the temperature inside
the connected buffer tank to it (depending on the
connection scheme)
- Summer Mode – Boiler works for heating of
domestic hot water only.
If you have selected the (CH +
DHW) option, upon
confirmation of command via
the F button you may navigate
to the next screen.
From this menu you can set up
and adjust DHW pump activity
periods. Use the arrow keys to
set time (HH:MM). Use “ Enter ”
button to checkmark desired
time period option. If no option is check-marked, the
controller will maintain DHW temperature as a