CAUTION!
LED (light-emitting diode) HAZARD. Removing the protective
covers and (when applicable) defeating the interlock(s) may result in exposure
to the internal LED. LEDs can burn the retina, causing permanent blind spots.
To ensure safe LED operation:
·
Never look directly into the light beam.
·
Wear proper eye protection and post a warning sign at the entrance to the
laboratory if the LED protection is defeated for servicing
·
Remove jewelry and other items that can reflect a light beam into your eyes
or those of others
·
Do not remove safety labels, instrument protective panels, or defeat safety
interlocks.
·
The system must be installed and maintained by a Thermo Fisher Scientific
Technical Representative.
WARNING!
Fuse Installation. Before installing the instrument, verify that the
fuses are properly installed and the fuse voltage matches the supply voltage.
Replace fuses only with the type and rating specified for the unit. Improper
fuses can damage the instrument wiring system and cause a fire.
WARNING!
Ensure appropriate electrical supply. For safe operation of the
instrument:
·
Plug the system into a properly grounded receptacle with adequate current
capacity.
·
Ensure the electrical supply is of suitable voltage.
·
Never operate the instrument with the ground disconnected. Grounding
continuity is required for safe operation of the instrument.
WARNING!
Power Supply Line Cords. Use properly configured and approved
line cords for the power supply in your facility.
WARNING!
Disconnecting Power. To fully disconnect power either detach or
unplug the power cord, positioning the instrument such that the power cord is
accessible.
LED (Light-
Emitting Diode)
Electrical
Appendix B
Safety
Instrument safety
B
iBright
™
Imaging Systems User Guide
39