![background image](http://html1.mh-extra.com/html/thermofisher-scientific/840-287100/840-287100_manual_1105620034.webp)
Installing the Nicolet iN5 Microscope
This document contains confidential or proprietary informat ion of Thermo Fisher Sc ientific. Ne ither this document nor
the information therein is to be reproduced, distributed, used or disclosed, either in whole o r in part, e xcept as
specifically authorized by Thermo Fisher Scientific.
1/4/2018
Page 34 of 84
c. Connect the 15 pin accessory cable between the spectrometer and the
iN5 Accessory connector on the I/O panel and tighten the thumbscrews.
Note
The accessory cable must be connected to the iS50 OBC right-side
accessory port; the side the iN5 is connected to.
Note
The photo below shows a USB cable connected to the I/O panel. You
will
not
receive a USB cable unless a “camera only” or a “trinoc and camera”
viewing option was ordered.
d. Install the purge Tee.
Turn the purge OFF and then cut the purge line from
the flow meter [to the spectrometer] so approximately 2-3 inches extends
from the flow meter. Connect the iS5 purge Tee as shown and then connect
to the iN5. Turn the purge ON.
e. Using a small flat-blade screwdriver, adjust the flow rate at the valve to
ensure a quiet, steady purge of dry air to the iN5.
Adjust flow rate by
adjusting valve
To spectrometer
To microscope