![background image](http://html1.mh-extra.com/html/thermofisher-scientific/840-287100/840-287100_manual_1105620065.webp)
Installing the Nicolet iN5 Microscope
This document contains confidential or proprietary informat ion of Thermo Fisher Sc ientific. Ne ither this document nor
the information therein is to be reproduced, distributed, used or disclosed, either in whole o r in part, e xcept as
specifically authorized by Thermo Fisher Scientific.
1/4/2018
Page 65 of 84
d. Define the video field of view center.
i. If you have a binocular viewer and camera installed, crop the
field of view on both the X and Y axis slightly (indicated by the
white dashed lines) and then move the gray calibration crosshair
so it is exactly on the end of the 50µm tic mark in the video
calibration screen.
The designated center point in the video
calibration screen should match what is viewed through the eyepieces.
Crop FOV slightly and mark edge of 50µm tic m ark
i. If you have only a camera installed, rotate the top knob on the X-
Y stage to move the 50µm tic mark down until it is out of the
aperture image.
Then, crop the field of view on both the X and Y axis
slightly (indicated by the white dashed lines) and move the gray
calibration crosshair so it is exactly in the center of the fixed 100µm
aperture image. Then, rotate the top knob counter-clockwise to center
the 50µm tic mark on the gray tick mark in the video calibration screen.
Crop FOV slightly and mark center of aperture im age
50µm tic mark back into the center of the aperture image
Crop the FOV on both
the X and Y axis a
small amount