Product Manual for IonPac CS16
Page 11 of 65
Document No. 031747-05
© 2010 Dionex Corporation
December 2010
NOTE
!
7.
Coil the separator column tubing inside the cartridge as shown in Figure 1 or Figure 2. Secure the column tubing and
the inlet fitting in the clips on the column cartridge.
8.
Secure the inlet and outlet fittings on the guard column (if used) in the column clips on the lid of the column
cartridge.
9.
Route the guard column inlet tubing (if used) or the separator column inlet tubing through the clip on the top edge of
the column cartridge lid.
10.
Close the lid (you should hear a click) and route the tubing into the slot on the front of the column cartridge (see
Figure 6).
If the columns are installed correctly, the cartridge lid snaps closed easily. If the lid does not close easily, do not
force it. Open the lid and verify that the columns and tubing are installed correctly and secured in the clips.
Separator Column Outlet
Column Inlet Tubing
1
2
1
2
Figure 6
Column Cartridge Closed
