9 Section 5 | Operation
5.2 Installation
1. Connect all the components according
to the figures shown on page 4 of this
manual. Use grounded power outlet.
Ensure the machine is on a flat
surface prior to operating.
2. Press down the power switch on the
back right side of the instrument and
put it to the “|” state and then the
instrument is in standby.
5.3 Accessory Installation
Only accessories that meet the
manufacturer's specifications shall be
used.
Angle Adjustment Method
1. Pull out the bolt.
Pull the bolt up
Note:
If the bolt cannot be pulled out,
please operate according to the
following instructions.
1) Turn the motor housing back and
forth gently by hand and pull the bolt
up at the same time.
Digital Cel-Gro Tissue Culture Rotator 10
2) If the bolt still cannot be pulled out,
please use vise grip plier to pull the
bolt up and turn the motor housing at
the same time.
3) Please contact us immediately if the
problem still exists.
2. Rotate the motor housing gently by
hand to adjust the angle.
3. Insert the bolt.
Note:
If the bolt does not fit completely,
Push the motor housing gently until the
bolt fits well.
4. Angle adjustment range is shown in
the following figures.
Single Tray Angle range
Mixing angle 146
°
Mixing angle
180
°
Mixing angle 112
°
Mixing angle
129
°
Mixing angle
163
°
Mixing angle
180
°
Mixing angle
163
°
Mixing angle 146
°
Mixing angle
129
°
Mixing angle 95
°
Mixing angle 112
°
Double Tray Angle range
