Engine Assembly (Rev 1/97)
76
59. Replace the rear seal by pressing the old seal out of the
rear seal housing and pressing a new seal in.
60. Coat the lip of the rear seal with engine oil.
61. Place a thin layer of sealant on the sealing surface of
the rear seal housing.
62. Place the rear seal housing in position and make sure to
align the dowel pins.
63. Install and tighten the mounting bolts for the rear seal
housing.
Install Rear Seal Housing
Install Starter Mounting Flange
aea324
aea325
64. Place the starter mounting flange in position on the rear
of the block and make sure to align the dowel pins.
65. Install and tighten the mounting bolts for the starter
mounting flange.
NOTE: The bolts at the bottom of the starter mount-
ing flange, which screw into the oil pan, are longer
than the other bolts that fasten the starter mounting
flange to the engine.
66. Install the flywheel and torque the flywheel mounting
bolts. Refer to Specifications for the recommended
torque.
67. Check to make sure the dowel pins are in position in the
timing gear housing.
Check Dowel Pins
68. Replace the front seal by pressing the old seal out of the
timing gear cover and pressing a new seal in.
69. Coat the lip of the front seal with engine oil.
aea326
