Therma-Steem® Model XL1
January 14, 2019
9
2.
Remove the air vent cap from the reservoir (on top of machine). Using the funnel
provided. Fill the reservoir with clean water, from a measured container, taking
care not to spill or overfill the reservoir tank (approx. 7 gal. when empty). Distilled
water is recommended.
3.
Plug the Vapor Steam Cleaner into an appropriate grounded outlet.
4.
Turn the MAIN Power switch to the “ON” position.
5.
Insert the 4 prong (208/220, 480, 575 volt), 3 phase power cord plug into an
appropriate electrical socket
6. Insert the 4 prong, 3 phase power cord plug end into an appropriate electrical
socket. Plug end may have to be supplied by the customer to match the existing
socket in the building. Make sure the voltage is still correct.
7. Then turn the MAIN POWER switch to the
“
ON
”
position. The green light will then
activate.
8. If the boiler requires water, the pump will activate, indicated by the
blue light and a “vibrating
-
type” sound.
The boiler will fill with approx.
4 gallons of water. It will take approximately 30 minutes to fill the
boiler when the boiler is empty.
9. After the pump sound ends and the blue light goes out, indicating the pump has
stopped, it is now safe for you to activate the HEATER switch. IMPORTANT:
NEVER
turn
“ON”
the HEATER switch until the pump has stopped, indicating the boiler is
full.
10.
Temperature reading is indicated by temperature gauge on panel. Temperature is
set by factory. DO NOT tamper with.
11. You may now top off the reservoir (at opening) with water, if desired, replacing
the reservoir vent cap.
12. When the boiler is at maximum temperature (about 3
65˚
F), the amber HEATER
light will cycle ON and OFF, indicating highest temperature. It will take
approximately 15 minutes to reach maximum temperature.
13. Place attachments on gun, ensuring that the connections are hand tightened.
14. Then, open the flow of steam with the steam control knob situated on the side of
the machine.
15. When the ADD WATER white light illuminates, the reservoir is empty. You may
elect to remove the reservoir vent cap and refill with water and resume cleaning.
16. When the blinking red light is activated, this indicates low water in the boiler, the
alarm will sound and the heater is de-activated. To re-activate the heater, fill the
reservoir. The pump will then fill the boiler from the reservoir. When the boiler
has cooled sufficiently (approx. 340
˚
F), the reset button (located under the red
