Themis RES-12XR3, Installation Manual

Page: 52 / 146

RES-12XR3 Installation Manual - Configuration 7 Version 1.1
2-6
Themis Computer
2. Before inserting a new memory module into the vacant slot, make sure that
the two latches are pulled outward away from the center of the slot.
With the latches in the outward position, gently insert the new module verti-
cally into its slot and press firmly downward until it snaps into place.
3. If all the memory modules have been replaced in the system, replace the air
flow diverter and secure it with the eight screws previously removed.
4. Replace the PCI card retainer bracket and secure it with the single screw
removed in Step 1 on page 2-9.
2.1.3 PCI Cards
Since the RES-12XR3 is only 1RU (1.75”) high, PCI cards must be installed hori-
zontally through one of the two PCI Riser Cards (see
Figure 2-5 on page 2-7).
Figure 2-4. Memory Module Removal
downward &
outward at
each end
Press latch
Note: Make sure the memory module has the proper orientation by align-
ing the alignment notch at the bottom edge with its counterpart ridge at
the bottom of the slot.